Linksys WiFi Extender Not Working Issue [Reasons and Fixes]
Nowadays, the Linksys WiFi range extenders have been causing a number of issues for users who have purchased them. One specific issue that is the most troublesome is the Linksys WiFi extender not working issue. In case you are also experiencing the same issue, then you ought to keep reading this blog post. Both the reasons as well as the solutions have been mentioned as you will see further.
What Caused Linksys WiFi Extender Not Working Issue?
1. Damaged Electrical Socket
Let us talk about the first reason why your Linksys wireless range extender is not working. It is a damaged wall socket due to which your networking device is not getting an adequate power supply to work properly.
2. Weak Ethernet Connection
Have you considered the possibility that your networking devices are connected via a damaged Ethernet cable? No? Well then, you ought to do now because due to this reason, signal transmission is not happening seamlessly.
3. More Than Required Space
Too much distance between the Linksys range extender and the host router is not good for the health of both networking devices. Due to this, you will also not be able to access the internet connection on client devices.
4. Damaged WiFi Extender
The last reason why you are experiencing the Linksys WiFi extender not working issue is that there is something wrong with your wireless range extender itself. Perhaps, it got damaged when it arrived at your house or while you were unpacking it for setup.
How to Fix Linksys WiFi Extender Not Working Issue?
1. Use Any Other Wall Socket
The very first thing that can be done from your end is to ensure that the wall socket to which your Linksys wireless range extender is even damaged or not. In case, it is, then you should plug your networking device into another wall socket. Make sure that it is located in the same room where the host router is kept. You might not understand this now but when you will gain speedy internet, you will know why we are suggesting you this.
2. Purchase Brand New Cable
Over time, cables get worn out. This is the reason why people these days prefer using a wireless source of connection instead of a wired source. But, now that you have already used a wire, then let us help you in that department. You have two options: Either tape up the existing cable or purchase a new one to connect the networking device. Just make sure that the connection which is being created is finger-tight. Leaving it loose will cause issues.
3. Bring WiFi Devices Closer
As said earlier, too much space is not good for your networking devices. To prevent their health from getting ruined any further, you should bring them closer. Just ensure that you are not keeping them too close to each other. Or else, the signals which are being emitted will clash. And if that happens, then not to sound too negative, but you can say goodbye to troubleshooting the Linksys WiFi extender not working issue forever.
4. Replace Linksys Extender
In case none of the solutions mentioned above help you to resolve the Linksys WiFi extender not working issue, then the reason is quite obvious, your device itself is damaged. Therefore, it is recommended that you get another one. What is that? Are you not in the mood of spending money? Worry not. If your Linksys range device is under warranty, then you will not have to pay a penny. The device will be replaced by the seller. Happy now?
Hence, these were the troubleshooting tips through which the Linksys WiFi extender not working issue can be put an end to. We are hoping that now you will be able to get your device up and running after Linksys extender setup. In case, you do, then do update the firmware of your networking device. This will ensure that you do not face any more technical issues with it in the future. Apart from this, it will also work on the overall performance of your wireless range extender. If you do not believe that this will even happen, perform Linksys extender firmware update now and see the result for yourself.